The Fit For The Job Cork Sanding Block does one thing well: it holds abrasive paper still while you work. Sand with paper wrapped round your hand and it slips, folds, and wears through in one spot. A block keeps the paper flat and the pressure even.

Cork is the right material for it. The surface has enough friction to grip the paper without any clamps, and the compressed cork does not swell or fall apart when it gets wet, so you can use it for wet sanding as well as dry.

Key Features of the Fit For The Job Cork Sanding Block

• High density compressed cork
• Will not swell or disintegrate with wet papers, even submerged
• Flat sides give uniform pressure for a consistent surface profile
• Bevelled edges so the block will not tear or rip papers
• High friction surface stops paper slipping
• Block size 11cm x 6cm, roughly 4″ x 2.5″
• Works with any abrasive paper sheet or roll

Where to Use

• Sanding filler flush before painting
• Keying gloss and satin between coats
• Preparing bare and previously painted wood
• Wet sanding gloss for a smooth finish
• Larger flat areas such as doors and panels
• Difficult surfaces where even pressure matters

How to Use the Fit For The Job Cork Sanding Block

1. Cut or tear your abrasive paper to wrap around the block.
2. Hold the paper against the flat face and wrap it round the sides.
3. Grip the loose ends against the sides as you work. The cork does the rest.
4. Sand with even pressure, working along the grain on timber.
5. Move the paper round the block as it wears rather than pressing harder.
6. For wet sanding, wet the paper and work with a light touch.
7. Rinse and air dry the block if you have used it wet.

Wet Sanding

Most cheap blocks fall apart the moment they get damp. This one does not, because the cork is compressed to a high density. That means you can use it with wet and dry paper on gloss or filler, which is how you get a genuinely smooth finish on woodwork rather than a scratched one.

Why Bevelled Edges Matter

A square-edged block digs into the paper as you push, and the paper tears at the corners. The bevelled edges on this block spread that load, so a sheet lasts noticeably longer. Small detail, but it is the difference between one sheet and three.

Sizes Available

Supplied as a single block measuring 11cm x 6cm, around 4″ x 2.5″. That suits a standard quarter sheet of abrasive paper folded round it.

Safety & Restrictions

• Wear a dust mask when sanding, particularly old paint
• Wear eye protection
• Keep out of reach of children
• Do not sand old paint that may contain lead without proper precautions
• Store dry between uses

Flat paper, even pressure, and it survives getting wet. The Fit For The Job Cork Sanding Block is a few pence well spent. Order yours today.